With increase in molecular weight of the gas, the head developed by a centrifugal compressor will Fluid Mechanics

  • Decrease
  • Increase
  • Remain same
  • Unpredictable
Answer: Decrease
1073 students attemted this question.

Explanation

No Explanation Available.

Share this question with friends

Similar Questions

  1. Liquid delivery by centrifugal pump starts, only when the head developed by it is equal to the __________ head.

  2. Water is flowing through a pipe of 5cm diameter under a pressure of 29.43N/cm2 (gauge) with mean velocity of 2m/s. Find the pressure head and kinetic head per unit weight of water at a cross section.

  3. A centrifugal pump is used to pump water through a horizontal distance of 150 m, and then raised to an overhead tank 10 m above. The pipe is smooth with an I.D of 50 mm. What head (m of water) must the pump generate at its exit (E) to deliver water at a flow rate of 0.001 m³/s? The Fanning friction factor, f is 0.0062.

  4. An object will _______ if the weight of it is equal to the weight of the water in which it is in.

  5. In a pool you have an apparent weight of 250 N, if there is 70N of force acitng on you, what would be your weight outside of the pool?

  6. Which one of the following is the dimension of Weight density/Specific Weight ?

  7. Find the Weight of the wooden block of width 2.5cm and depth 1.5m, when its floating horizontally in water. The specific weight of of wooden block is 6376.5N/m3

  8. If the head over the triangular notch is doubled, the discharge will increase by __________ times.

  9. Interstage coolers are provided in a multistage compressor to

  10. We can increase the pressure of a gas by:

  11. Priming of a centrifugal pump is done to

  12. Cavitation in a centrifugal pump can be avoided by keeping the

  13. Cavitation in a centrifugal pump results from

  14. Reciprocating pumps compared to centrifugal pumps

  15. While starting a centrifugal pump, its delivery valve should be kept

  16. Calculate the discharge through the venturimeter which is used to measure the flow of water if the area at inlet and throat are 706.85 cm2 and 176.7cm2 and difference of pressure head is 252m of water.

  17. Which of the following pipe bends will incur the largest head loss ?

  18. The length of the tube necessary for the boundary layer to reach the centre of the tube and for fully developed flow to be established is called the __________ length.

  19. The power transmitted through a pipe is (where w = Specific weight in N/m3, and Q = Discharge in m3/s)

  20. According to Archimede's principle, if a body is immersed partially or fully in a fluid then the buoyancy force is _______ the weight of fluid displaced by the body.

Comments

Add Your Review

Your email address will not be published.

Subscribe to Newsletter!

Subscribe to get latest updates and information.