While starting a centrifugal pump, its delivery valve should be kept Fluid Mechanics

  • Opened
  • Closed
  • Either opened or closed ; it does not make any difference
  • Either opened or closed; depending on the fluid viscosity
Answer: Closed
1808 students attemted this question.

Explanation

No Explanation Available.

Share this question with friends

Similar Questions

  1. While starting an axial flow pump, its delivery valve should be kept

  2. A centrifugal pump is used to pump water through a horizontal distance of 150 m, and then raised to an overhead tank 10 m above. The pipe is smooth with an I.D of 50 mm. What head (m of water) must the pump generate at its exit (E) to deliver water at a flow rate of 0.001 m³/s? The Fanning friction factor, f is 0.0062.

  3. Liquid delivery by centrifugal pump starts, only when the head developed by it is equal to the __________ head.

  4. The inherent characteristic of an equal percentage valve relating flow rate 'q' with valve stem movement 'x' are described by the equation

  5. Purpose of relief valve in a reciprocating pump is to

  6. Priming of a centrifugal pump is done to

  7. Cavitation in a centrifugal pump can be avoided by keeping the

  8. Cavitation in a centrifugal pump results from

  9. Boiler feed water pump is usually a __________ pump.

  10. With increase in molecular weight of the gas, the head developed by a centrifugal compressor will

  11. Reciprocating pumps compared to centrifugal pumps

  12. __________ pump is the most suitable device for discharging a liquid against a pressure of ≥ 1500 kgf/cm².

  13. A hydraulic ram acts as a/an __________ pump.

  14. Which of the following is the most common pump for pumping either raw sewage or sludge?

  15. Function of air vessel provided in a reciprocating pump is to

  16. The entrance of a pipe has a cross-sectional area of 0.6 m2, while the exit's area is 0.2 m2. If an ideal fluid enters the pipe at a speed of 1.5 m/s, at what speed does it leaves the pipe?

  17. For pipes that must be broken at intervals for maintenance, the connector used should be a/an

  18. If a body floating in a liquid returns back to its original position, when given a small angular displacement, the body is said to be in

  19. Frank has an eraser. It has a mass of 4g, and a volume of 2cm3. What is its density?

  20. Diagram shows the design of a dam. Why does the thickness of the dam increase with its depth?

Comments

Add Your Review

Your email address will not be published.

Subscribe to Newsletter!

Subscribe to get latest updates and information.