### Explanation

No Explanation Available.

### Share this question with friends

### Similar Questions

### If the tearing efficiency of a riveted joint is 50%, then ratio of rivet hole diameter to the pitch of rivets is

### The object of caulking in a riveted joint is to make the joint

### The maximum diameter of the hole that can be punched from a plate of maximum shear stress 1/4th of its maximum crushing stress of punch, is equal to (where t = Thickness of the plate)

### The rectangular beam 'A' has length l, width b and depth d. Another beam 'B' has the same length and depth but width is double that of 'A'. The elastic strength of beam 'B' will be __________ as compared to beam A.

### If the depth is kept constant for a beam of uniform strength, then its width will vary in proportional to (where M = Bending moment)

### The stress induced in a body, when suddenly loaded, is __________ the stress induced when the same load is applied gradually.

### If the slenderness ratio for a column is 100, then it is said to be a __________ column.

### In order to prevent crushing of masonry at the base of the dam, the maximum stress should be __________ the permissible stress of the soil.

### The bending moment at a point on a beam is the algebraic __________ of all the moments on either side of the point.

### The bending stress in a beam is __________ section modulus.

### When shear force at a point is zero, then bending moment is __________ at that point.

### Whenever a material is loaded within elastic limit, stress is __________ strain.

### A load which is spread over a beam in such a manner that it varies uniformly over the whole length of abeam is called uniformly __________ load.

### The angle which an inclined plane makes with the horizontal when a body placed on it is about to move down is known as angle of

### The energy stored in a body when strained within elastic limit is known as

### A composite shaft consisting of two stepped portions having spring constants k1 and k2 is held between two rigid supports at the ends. Its equivalent spring constant is

### Two coplanar couples having equal and opposite moments

### The magnitude of two forces, which when acting at right angle produce resultant force of VlOkg and when acting at 60° produce resultant of Vl3 kg. These forces are

### In determining stresses in frames by methods of sections, the frame is divided into two parts by an imaginary section drawn in such a way as not to cut more than

### A trolley wire weighs 1.2 kg per meter length. The ends of the wire are attached to two poles 20 meters apart. If the horizontal tension is 1500 kg find the dip in the middle of the span