The phenolic compounds in public water supply should not be more than Environmental Engineering

  • 0.1 ppm
  • 0.01 ppm
  • 0.001 ppm
  • 0.0001 ppm
Answer: 0.001 ppm
1017 students attemted this question.

Explanation

No Explanation Available.

Share this question with friends

Similar Questions

  1. The amount of residual chlorine left in public water supply for safety against pathogenic bacteria is about

  2. The amount of coagulant needed for coagulation of water increases with (i) Increase in turbidity of water (ii) Decrease in turbidity of water (iii) Increase in temperature of water (iv) Decrease in temperature of waterThe correct answer is

  3. The length of rectangular sedimentation tank should not be more than(Where ‘B’ is the width of the tank)

  4. If the total hardness of water is greater than its total alkalinity, the carbonate hardness will be equal to

  5. The minimum dissolved oxygen which should always be present in water in order to save the aquatic life is

  6. The method of analysis of distribution system in which the domestic supply is neglected and fire demand is considered is

  7. Residual chlorine in water is determined by

  8. The water carriage system of collection of waste product

  9. In chlorination, with the rise in temperature of water, death rate of bacteria

  10. Disinfection of water results in

  11. In water treatment, rapid gravity filters are adopted to remove

  12. The polluted water is one which

  13. The maximum permissible limit for fluoride in drinking water is

  14. If the coli form bacteria is present in a sample of water, then the coli-form test to be conducted is (i) Presumptive coli-form test (ii) Confirmed coli-form test (iii) Completed coli-form test

  15. Percentage of bacterial load that can be removed from water by the process of plain sedimentation is about

  16. Which of the following is not a water borne disease?

  17. The type of valve which allows water to flow in one direction but prevents its flow in the reverse direction is

  18. A pipe which is installed in the house drainage to preserve the water seal of traps is called

  19. The percentage of filtered water, which is used for backwashing in rapid sand filters, is about

  20. The most common cause of acidity in water is

Comments

Add Your Review

Your email address will not be published.

Subscribe to Newsletter!

Subscribe to get latest updates and information.