The maximum stress produced in a bar of tapering section is at Strength of Materials
Answer: smaller end
No Explanation Available.
Share this question with friends
A body is subjected to a tensile stress of 1200 MPa on one plane and another tensile stress of 600 MPa on a plane at right angles to the former. It is also subjected to a shear stress of 400 MPa on the same planes. The maximum normal stress will be
The maximum diameter of the hole that can be punched from a plate of maximum shear stress 1/4th of its maximum crushing stress of punch, is equal to (where t = Thickness of the plate)
In order to prevent crushing of masonry at the base of the dam, the maximum stress should be __________ the permissible stress of the soil.
The stress induced in a body, when suddenly loaded, is __________ the stress induced when the same load is applied gradually.
A steel bar of 5 mm is heated from 15° C to 40° C and it is free to expand. The bar Will induce
The neutral axis of the cross-section a beam is that axis at which the bending stress is
The bending stress in a beam is __________ section modulus.
A thick cylindrical shell having ro and ri as outer and inner radii, is subjected to an internal pressure (p). The maximum tangential stress at the inner surface of the shell is
The torque transmitted by a solid shaft of diameter (D) is (where τ = Maximum allowable shear stress)
When a rectangular beam is loaded transversely, the maximum compressive stress is developed on the
When a body is subjected to two equal and opposite pushes, as a result of which the body tends to reduce its length, the stress and strain induced is compressive.
In a simple bending of beams, the stress in the beam varies
The stress at which the extension of the material takes place more quickly as compared to the increase in load, is called
The strain energy stored in a solid circular shaft subjected to shear stress (τ) is (where C = Modulus of rigidity for the shaft material)
Whenever a material is loaded within elastic limit, stress is __________ strain.
When a bar is cooled to - 5°C, it will develop
In determining stresses in frames by methods of sections, the frame is divided into two parts by an imaginary section drawn in such a way as not to cut more than
The simply supported beam 'A' of length l carries a central point load W. Another beam 'B' is loaded with a uniformly distributed load such that the total load on the beam is W. The ratio of maximum deflections between beams A and B is