The flow in a pipe is laminar when Reynold number is Fluid Mechanics

  • less than 2000
  • between 2000 and 4000
  • more than 4000
  • none of these
Answer: less than 2000
1233 students attemted this question.

Explanation

No Explanation Available.

Share this question with friends

Similar Questions

  1. Applying a pressure drop across a capillary results in a volumetric flow rate 'Q' under laminar flow conditions. The flow rate for the same pressure drop, in a capillary of the same length but half the radius is

  2. Two fluids are flowing through two similar pipes of the same diameter. The Reynold's number is same. For the same flow rate if the viscosity of a fluid is reduced to half the value of the first fluid, the pressure drop will

  3. The entrance of a pipe has a cross-sectional area of 0.6 m2, while the exit's area is 0.2 m2. If an ideal fluid enters the pipe at a speed of 1.5 m/s, at what speed does it leaves the pipe?

  4. The Areas of a pipe at section 1 and 2 are 0.007854m2 and 0.017m2. Find the discharge through the pipe if the velocity of water flowing through the pipe at section 1 is 5m/s. Find the velocity of water at section 2.

  5. For turbulent fluid flow in pipe, the expression for Prandtl one seventh power law is (where, r = pipe radius, x = distance).

  6. Which of the following is NOT an example of laminar flow?

  7. How can we determine whether the flow is laminar or turbulent?

  8. For laminar flow through a closed conduit

  9. The energy loss in flow through ven-turimeter is less than that through flow nozzle, because in case of a flow nozzle, the

  10. The device used for measuring the velocity of flow at any point in a pipe or channel is

  11. Pressure drop (Δp) for a fluid flowing in turbulent flow through a pipe is a function of velocity (V) as

  12. Water flow rate in a pipe of 3.5 metres diameter can be most economically and conveniently measured by a/an

  13. A centrifugal pump is used to pump water through a horizontal distance of 150 m, and then raised to an overhead tank 10 m above. The pipe is smooth with an I.D of 50 mm. What head (m of water) must the pump generate at its exit (E) to deliver water at a flow rate of 0.001 m³/s? The Fanning friction factor, f is 0.0062.

  14. In one dimensional flow, the flow

  15. Bernoulli's equation cannot be used for flow of water in river because the flow is

  16. In which type of fluid flow, the velocity of flow of fluid changes from point to point in the fluid at any instant?

  17. The power transmitted through a pipe is (where w = Specific weight in N/m3, and Q = Discharge in m3/s)

  18. Water is flowing through a pipe of 5cm diameter under a pressure of 29.43N/cm2 (gauge) with mean velocity of 2m/s. Find the pressure head and kinetic head per unit weight of water at a cross section.

  19. What is the value of Fanning friction factor f ' for smooth pipe at NRe = 10⁶ approximately?

  20. Shear stress in a fluid flowing in a round pipe

Comments

Add Your Review

Your email address will not be published.

Subscribe to Newsletter!

Subscribe to get latest updates and information.