The amount of coagulant needed for coagulation of water increases with (i) Increase in turbidity of water (ii) Decrease in turbidity of water (iii) Increase in temperature of water (iv) Decrease in temperature of waterThe correct answer is Environmental Engineering

  • (i) and (ii)
  • (i)and(iv)
  • (ii) and (iii)
  • (ii) and (iv)
Answer: (i)and(iv)
1239 students attemted this question.

Explanation

No Explanation Available.

Share this question with friends

Similar Questions

  1. As compared to rapid sand filters, slow sand filters give (i) Slower filtration rate (ii) Higher filtration rate (iii) Lesser efficiency in removal of bacteria (iv) Higher efficiency in removal of bacteria The correct answer is

  2. Cleaning is done by (i) Scraping and removal in filters slow sand (ii) Back washing in slow sand filters (iii) Scraping and removal in filters rapid sand (iv) Back washing in rapid sand filtersThe correct answer is

  3. If the coli form bacteria is present in a sample of water, then the coli-form test to be conducted is (i) Presumptive coli-form test (ii) Confirmed coli-form test (iii) Completed coli-form test

  4. As compared to geometrical increase method of forecasting population, arithmetical increase method gives

  5. Septic tank is a (i) Settling tank (ii) Digestion tank (iii) Aeration tank

  6. The amount of residual chlorine left in public water supply for safety against pathogenic bacteria is about

  7. In chlorination, with the rise in temperature of water, death rate of bacteria

  8. The dissolved oxygen level in natural unpolluted waters at normal temperature is found to be of the order of

  9. The correct relation between theoretical oxygen demand (TOD), Biochemical oxygen demand (BOD) and Chemical oxygen demand (COD) is given by

  10. Select the correct relationship between porosity (N), specific yield (y) and specific retention (R)

  11. Residual chlorine in water is determined by

  12. The phenolic compounds in public water supply should not be more than

  13. The water carriage system of collection of waste product

  14. Disinfection of water results in

  15. If the total hardness of water is greater than its total alkalinity, the carbonate hardness will be equal to

  16. In water treatment, rapid gravity filters are adopted to remove

  17. The polluted water is one which

  18. The maximum permissible limit for fluoride in drinking water is

  19. The minimum dissolved oxygen which should always be present in water in order to save the aquatic life is

  20. Percentage of bacterial load that can be removed from water by the process of plain sedimentation is about

Comments

Add Your Review

Your email address will not be published.

Subscribe to Newsletter!

Subscribe to get latest updates and information.