Percentage of bacterial load that can be removed from water by the process of plain sedimentation is about Environmental Engineering

  • 10 to 25
  • 50
  • 75
  • 100
Answer: 75
1866 students attemted this question.

Explanation

No Explanation Available.

Share this question with friends

Similar Questions

  1. The length of rectangular sedimentation tank should not be more than(Where ‘B’ is the width of the tank)

  2. The amount of coagulant needed for coagulation of water increases with (i) Increase in turbidity of water (ii) Decrease in turbidity of water (iii) Increase in temperature of water (iv) Decrease in temperature of waterThe correct answer is

  3. The percentage of filtered water, which is used for backwashing in rapid sand filters, is about

  4. The percentage of chlorine in fresh bleaching powder is about

  5. Residual chlorine in water is determined by

  6. The phenolic compounds in public water supply should not be more than

  7. The water carriage system of collection of waste product

  8. In chlorination, with the rise in temperature of water, death rate of bacteria

  9. Disinfection of water results in

  10. If the total hardness of water is greater than its total alkalinity, the carbonate hardness will be equal to

  11. In water treatment, rapid gravity filters are adopted to remove

  12. The polluted water is one which

  13. The amount of residual chlorine left in public water supply for safety against pathogenic bacteria is about

  14. The maximum permissible limit for fluoride in drinking water is

  15. The minimum dissolved oxygen which should always be present in water in order to save the aquatic life is

  16. If the coli form bacteria is present in a sample of water, then the coli-form test to be conducted is (i) Presumptive coli-form test (ii) Confirmed coli-form test (iii) Completed coli-form test

  17. Which of the following is not a water borne disease?

  18. The type of valve which allows water to flow in one direction but prevents its flow in the reverse direction is

  19. A pipe which is installed in the house drainage to preserve the water seal of traps is called

  20. The most common cause of acidity in water is

Comments

Add Your Review

Your email address will not be published.

Subscribe to Newsletter!

Subscribe to get latest updates and information.