In determining stresses in frames by methods of sections, the frame is divided into two parts by an imaginary section drawn in such a way as not to cut more than Strength of Materials

  • Two members with unknown forces of the frame
  • Three members with unknown forces of the frame
  • Four members with unknown forces of the frame
  • Three members with known forces of the frame
Answer: Three members with unknown forces of the frame
1124 students attemted this question.

Explanation

No Explanation Available.

Share this question with friends

Similar Questions

  1. If n = number of members andy = number of joints, then for a perfect frame, n =

  2. A framed structure is perfect if it contains members equal to (where n = number of joints in a frame)

  3. Which of the following is the locus of a point that moves in such a manner that its distance from a fixed point is equal to its distance from a fixed line multiplied by a constant greater than one

  4. The neutral axis of the cross-section a beam is that axis at which the bending stress is

  5. The maximum stress produced in a bar of tapering section is at

  6. The bending stress in a beam is __________ section modulus.

  7. The simply supported beam 'A' of length l carries a central point load W. Another beam 'B' is loaded with a uniformly distributed load such that the total load on the beam is W. The ratio of maximum deflections between beams A and B is

  8. A load which is spread over a beam in such a manner that it varies uniformly over the whole length of abeam is called uniformly __________ load.

  9. A composite shaft consisting of two stepped portions having spring constants k1 and k2 is held between two rigid supports at the ends. Its equivalent spring constant is

  10. When two main plates are kept in alignment butting each other and riveted with cover plate on both sides of the main plates with two rows of rivets in each main plate, the joint is known as __________ double cover butt joint.

  11. The stress at which the extension of the material takes place more quickly as compared to the increase in load, is called

  12. When trying to turn a key into a lock, following is applied

  13. Two coplanar couples having equal and opposite moments

  14. The magnitude of two forces, which when acting at right angle produce resultant force of VlOkg and when acting at 60° produce resultant of Vl3 kg. These forces are

  15. A trolley wire weighs 1.2 kg per meter length. The ends of the wire are attached to two poles 20 meters apart. If the horizontal tension is 1500 kg find the dip in the middle of the span

  16. Two non-collinear parallel equal forces acting in opposite direction

  17. A vertical column has two moments of inertia (i.e. Ixx and Iyy ). The column will tend to buckle in the direction of the

  18. Two shafts 'A' and 'B' transmit the same power. The speed of shaft 'A' is 250 r.p.m. and that of shaft 'B' is 300 r.p.m. The shaft 'B' has the greater diameter.

  19. When a body is subjected to two equal and opposite pushes, as a result of which the body tends to reduce its length, the stress and strain induced is compressive.

  20. Two closely coiled helical springs 'A' and 'B' are equal in all respects but the number of turns of spring 'A' is half that of spring 'B' The ratio of deflections in spring 'A' to spring 'B' is

Comments

Add Your Review

Your email address will not be published.

Subscribe to Newsletter!

Subscribe to get latest updates and information.