A pipe which is installed in the house drainage to preserve the water seal of traps is called Environmental Engineering

  • Vent pipe
  • Anti-siphonage pipe
  • Waste pipe
  • Soil pipe
Answer: Anti-siphonage pipe
1540 students attemted this question.

Explanation

No Explanation Available.

Share this question with friends

Similar Questions

  1. The amount of coagulant needed for coagulation of water increases with (i) Increase in turbidity of water (ii) Decrease in turbidity of water (iii) Increase in temperature of water (iv) Decrease in temperature of waterThe correct answer is

  2. A sewer that receives the discharge of a number of house sewers is called

  3. The polluted water is one which

  4. The minimum dissolved oxygen which should always be present in water in order to save the aquatic life is

  5. Which of the following is not a water borne disease?

  6. The type of valve which allows water to flow in one direction but prevents its flow in the reverse direction is

  7. The percentage of filtered water, which is used for backwashing in rapid sand filters, is about

  8. Residual chlorine in water is determined by

  9. The phenolic compounds in public water supply should not be more than

  10. The water carriage system of collection of waste product

  11. In chlorination, with the rise in temperature of water, death rate of bacteria

  12. Disinfection of water results in

  13. If the total hardness of water is greater than its total alkalinity, the carbonate hardness will be equal to

  14. In water treatment, rapid gravity filters are adopted to remove

  15. The amount of residual chlorine left in public water supply for safety against pathogenic bacteria is about

  16. The maximum permissible limit for fluoride in drinking water is

  17. If the coli form bacteria is present in a sample of water, then the coli-form test to be conducted is (i) Presumptive coli-form test (ii) Confirmed coli-form test (iii) Completed coli-form test

  18. Percentage of bacterial load that can be removed from water by the process of plain sedimentation is about

  19. The most common cause of acidity in water is

  20. Which of the following values of pH represents a stronger acid?

Comments

Add Your Review

Your email address will not be published.

Subscribe to Newsletter!

Subscribe to get latest updates and information.