A composite shaft consisting of two stepped portions having spring constants k1 and k2 is held between two rigid supports at the ends. Its equivalent spring constant is Strength of Materials
No Explanation Available.
Share this question with friends
Two shafts 'A' and 'B' transmit the same power. The speed of shaft 'A' is 250 r.p.m. and that of shaft 'B' is 300 r.p.m. The shaft 'B' has the greater diameter.
Two closely coiled helical springs 'A' and 'B' are equal in all respects but the number of turns of spring 'A' is half that of spring 'B' The ratio of deflections in spring 'A' to spring 'B' is
The strain energy stored in a solid circular shaft subjected to shear stress (τ) is (where C = Modulus of rigidity for the shaft material)
Which of the following is the locus of a point that moves in such a manner that its distance from a fixed point is equal to its distance from a fixed line multiplied by a constant greater than one
A beam supported at its both ends is not a simply supported beam.
If three forces acting in one plane upon a rigid body, keep it in equilibrium, then they must either
If a rigid body is in equilibrium under the action of three forces, then
A trolley wire weighs 1.2 kg per meter length. The ends of the wire are attached to two poles 20 meters apart. If the horizontal tension is 1500 kg find the dip in the middle of the span
The torque transmitted by a solid shaft of diameter (D) is (where τ = Maximum allowable shear stress)
If the depth is kept constant for a beam of uniform strength, then its width will vary in proportional to (where M = Bending moment)
Two coplanar couples having equal and opposite moments
A thick cylindrical shell having ro and ri as outer and inner radii, is subjected to an internal pressure (p). The maximum tangential stress at the inner surface of the shell is
A body moves, from rest with a constant acceleration of 5 m per sec. The distance covered in 5 sec is most nearly
When a body is subjected to two equal and opposite pushes, as a result of which the body tends to reduce its length, the stress and strain induced is compressive.
When two main plates are kept in alignment butting each other and riveted with cover plate on both sides of the main plates with two rows of rivets in each main plate, the joint is known as __________ double cover butt joint.
The C.G. of a plane lamina will not be at its geometrical centre in the case of a
The maximum diameter of the hole that can be punched from a plate of maximum shear stress 1/4th of its maximum crushing stress of punch, is equal to (where t = Thickness of the plate)
In order to know whether a column is long or short, we must know its slenderness ratio.
Coulomb friction is the friction between
The simply supported beam 'A' of length l carries a central point load W. Another beam 'B' is loaded with a uniformly distributed load such that the total load on the beam is W. The ratio of maximum deflections between beams A and B is