Sign In / Sign Up
Explanation
No Explanation Available.
Share this question with friends
Similar Questions
What is the value of Fanning friction factor f ' for smooth pipe at NRe = 10⁶ approximately?
The Areas of a pipe at section 1 and 2 are 0.007854m2 and 0.017m2. Find the discharge through the pipe if the velocity of water flowing through the pipe at section 1 is 5m/s. Find the velocity of water at section 2.
The entrance of a pipe has a cross-sectional area of 0.6 m2, while the exit's area is 0.2 m2. If an ideal fluid enters the pipe at a speed of 1.5 m/s, at what speed does it leaves the pipe?
Water is flowing through a pipe of 5cm diameter under a pressure of 29.43N/cm2 (gauge) with mean velocity of 2m/s. Find the pressure head and kinetic head per unit weight of water at a cross section.
Liquid delivery by centrifugal pump starts, only when the head developed by it is equal to the __________ head.
For turbulent fluid flow in pipe, the expression for Prandtl one seventh power law is (where, r = pipe radius, x = distance).
The energy loss in flow through ven-turimeter is less than that through flow nozzle, because in case of a flow nozzle, the
Applying a pressure drop across a capillary results in a volumetric flow rate 'Q' under laminar flow conditions. The flow rate for the same pressure drop, in a capillary of the same length but half the radius is
Calculate the discharge through the venturimeter which is used to measure the flow of water if the area at inlet and throat are 706.85 cm2 and 176.7cm2 and difference of pressure head is 252m of water.
Water flow rate in a pipe of 3.5 metres diameter can be most economically and conveniently measured by a/an
While starting a centrifugal pump, its delivery valve should be kept
With increase in molecular weight of the gas, the head developed by a centrifugal compressor will
Pressure drop (Δp) for a fluid flowing in turbulent flow through a pipe is a function of velocity (V) as
Which of the following pipe bends will incur the largest head loss ?
Priming of a centrifugal pump is done to
Cavitation in a centrifugal pump can be avoided by keeping the
Cavitation in a centrifugal pump results from
The device used for measuring the velocity of flow at any point in a pipe or channel is
Bernoulli's equation cannot be used for flow of water in river because the flow is
Which of the following must be followed by the flow of a fluid (real or ideal)? (I) Newton's law of viscosity.(II) Newton's second law of motion. (III) The continuity equation.(IV) Velocity of boundary layer must be zero relative to boundary.(V) Fluid cannot penetrate a boundary.
Comments
Add Your Review
Ask a Question
